All you need is:
-2 contrasting fabrics (5/8 yd of each)
-2 yards on ribbon (for top strap)
Start with your 2 contrasting fabrics. They should be about 24″ each. Pin and sew right sides together but on one side, leave a 2″ opening (just like you would if you were sewing a pillow).
Turn the apron inside-out (really right side-out) by pushing all of the fabric through the opening. Once apron has been all turned out, put your finger inside to push out the corners. Iron the apron flat (and pretty!)
Now you need to add the accent ribbon. Measure (or don’t) about 5″ from the bottom of the apron. Pin the accent ribbon and sew it on. Don’t worry about the edges because you will finish it with the quilting binding.
Time for pleats. I learned a bunch of “fancy” ways to pleat in college but, sorry Prof. Hargrove… Just find the center of the apron. Pull about 2-2.5″ back, fold fabric in to meet in the middle then then lay the sides down to make little “doors” on the fabric.
Do this 2 more times… measure about 4-5 inches on both sides of the middle to make a total of 3 pleats.
Almost done… pin your quilt binding on the 2 sides and the bottom (not the top!). When you come to the corners, fold them under and down like you are making the corner of a bed.
Lastly, time to pin the ribbon (which will be the wait-tie) onto the apron. You will sew it right onto the front. I pinned mine from the back because with my ribbon it was easier from the back to line up and sew a straight line.
Fold the ends of the ribbon and sew to prevent fraying…. and voila! A Midi apron!
